User Manual

MM200-M MiniCard

Field Description

Extension Channel

Sets the extension channel mode when bandwidth is 40 MHz.

Available options are

Auto, None, Lower, and Upper. The default is Auto.

Antenna Selection

Sets the antenna selections. Available options are Auto, An-

tenna A, Antenna B, 2 by 2,

and 2 by 3. The default is Auto.

Note

The fields Wireless Mode and Preferred Channel are used only when an Ad-Hoc network is started by the

client card. These two attributes are ignored if the client card is connected to an existing Ad-Hoc network with

the same desired SSID.

3.2.2 Profile Setting—Security Tab

Clicking the Security tab displays the following security options:

. • Authentication Mode

. • Encryption Mode (Security off, WEP, TKIP, and AES)

. • WEP Key Setting (Passphrase Key or Authentication Protocol)

Figure 12

Security tab

3.2.2.1 Non-EAP Authentication Modes

The MM200-M Configuration Utility currently supports the following non-EAP authentication modes:

. • Open System—Open Authentication (no key or a pre-shared WEP key is

. required).

. • Shared Key—Shared Authentication (a pre-shared WEP key is required)

. • Auto Switch—Auto Select Authentication modes (Open System or Shared

. Key, WEP key required)

. • WPA-PSK—WPA Pre-Shared Key

. • WPA2-PSK—WPA2 Pre-Shared Key