User's Manual

Administering Your Cisco RV 120W
Using Diagnostic Tools
Cisco RV 120W Administration Guide 130
7
To configure access control rules:
STEP 1 In the A
Access Control List Table,
click A
Add
.
STEP 2 Enter the IP Address of the specific SNMP manager or trap agent on which to
create an access rule.
STEP 3 Enter the subnet mask used to determine the list of allowed SNMP managers.
STEP 4 Enter the community string to which the agent belongs. Most agents are
configured to listen for traps in the Public community.
STEP 5 Choose the access type. The SNMP manager or trap agent can either be allowed
to read and modify all SNMP accessible settings (r
rwcommunity
) or be given read-
only access (r
rocommunity
).
STEP 6 Click S
Save
.
Configuring Additional SNMP Information
To configure additional SNMP information:
STEP 1 Choose A
Administration
> N
Network Management
> S
SNMP System Information
. This
page displays the current SNMP configuration of the router. The following MIB
(Management Information Base) fields are displayed and can be modified:
•
SysContact
—Enter the name of the contact person for this router.
Examples: admin, John Doe.
•
SysLocation
—Enter the physical location of the router. Example: Rack #2,
4th Floor.
•
SysName
—Enter a name for easy identification of the router.
STEP 2 Click S
Save
.
Using Diagnostic Tools
The Cisco RV 110W provides several diagnostic tools. To access these tools,
choose A
Administration
> N
Network Tools
.