User's Manual
Table Of Contents
- Regulatory Compliance and Safety Information for the Cisco Small Business Wired and Wireless Routers, and Access Points (EMC Class B Devices)
- Translated Safety Warnings
- European Directives
- Statement 6003-Taiwan Battery
- Statement 6005-California Perchlorate Contamination Prevention Act (Title 22, California Code of Regulations, Chapter 33)
- EMC Class B Notices and Warnings
- Japanese Electric Appliance and Radio Laws
- Radio
- Product Usage Restrictions
- Generic Discussion on RF Exposure
- Declarations of Conformity
- Product Resources
18
Regulatory Compliance and Safety Information for the Cisco Small Business Wired and Wireless Routers, and Access Points (EMC
78-19314-01
EMC Class B Notices and Warnings
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Safety Notice
To comply with FCC/IC RF Exposure Limits set forth for an uncontrolled environment, the product must
be installed and operated with a minimum separation distance (between nearby person(s) and radiating
antenna) according to the following scenarios:
• 20cm minimum when the product is operated alone without co-transmitting with a plug-in 3G USB
dongle device.
• 33cm minimum when the product is operated with a plug-in 3G USB device which has maximum
of 7W ERP output power.
• For co-transmission scenario which is not covered above, please consult the RF technician or device
supplier.
Class B Notice for Canada
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit
pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris
un brouillage susceptible de provoquer un fonctionnement indésirable.
AVERTISSEMENT DE SECURITE CONCERNANT LES EXPOSITIONS AUX
FREQUENCES RADIO
Pour etre conforme aux limites d’exposition aux frequences radio FCC/IC etablies pour un
environnement non controle (utilisation par le grand public), l’equipement doit etre installe et utilise en
laissant une distance de separation de securite (entre la ou les personnes presentes dans le perimetre et
l’antenne d’emission) selon les cas suivants:
• 20cm au minimum quand le produit est utilise seul sans co-transmettre a l’aide d’un appareil 3G
USB enfichable.