User's Manual

Broadband Wireless Router User Guide
- 24 -
 Firmware Version This field shows the installed version of the firmware.
 Administrator Password Enter the password you want to use into the
“Password Change” field and re-enter it into the “Password Confirm”
field for confirmation. Be sure that the password is less than 64 characters
long and without any special characters or spaces.
 WAN MAC Change The WAN MAC address can be changed from the
original values if necessary. Some ISPs require users to change the WAN
MAC address to a registered one when users change their access equipment.
 Remote Management Check “Enable” to allow you to configure the
Advanced Wireless 11g Router from the WAN side. To access the setting
page from the external side, enter “http://<WAN IP Address>:8080” into
the web browser address bar and press the “Enter” key.
 MTU Check Enable if you want to set a maximum limitation for incoming
and outgoing packet size. Enter the maximum packet size you wish to set in
the “Size” column.
 Reset Device Select “Yes” if you want to clear a connection, reboot, and
re-initialize the unit without affecting any of your configuration setting.
 Factory Defaults Select “Yes” if you want to return all the router’s current
settings to their factory defaults. Note that do not restore the factory defaults
unless it is absolutely necessary.
Click “Apply” after making any changes.
4-6 Status Monitor
This screen shows the router’s current status. All of the information provided is