User's Manual

Broadband Wireless Router User Guide
- 26 -
 DHCP Clients Table If the router is setup to act as a DHCP server, the LAN
side IP Address distribution table will appear by clicking this button.
4-7 Dynamic Routing
The Dynamic Routing feature allows your Advanced Wireless 11g Router to exchange
routing information with other routers in the network. Enabling this feature is likely to
enhance performance of your Advanced Wireless 11g Router.
 TX From the drop-down list, select one of the routing information types,
“RIP-1”, “RIP-1 Compatible”, or “RIP-2”, to enable the “TX” (transmit)
function. “RIP-1” is the protocol used by older routers. Newer routers
should use “RIP-2” or “RIP-1 Compatible” servers to broadcast RIP-1
and multicast RIP-2.
 RX From the drop-down list, select one of the routing information types,
“RIP-1” or “RIP-2”, to enable the “RX” (receive) function.
Click “Apply” after making any changes.
4-8 Static Routing
The Static Routing feature allows PCs that are connected to the Advanced Wireless
11g Router, either directly or through a hub/switch (in the immediate LAN), to
communicate with other PCs in the respective LAN segment which are connected to
the Advanced Wireless 11g Router through another router (destination LAN). Up to 20
route entries may be input into the Advanced Wireless 11g Router. The diagram below
gives an example of the physical connections required to use Static Routing.