CyberTAN User Manual WU182-LO 802.11 b/g/n USB Module Release 0.
Table of Contents 1. REVISION HISTORY ......................................................................................................................... 1 2. RELATED DOCUMENTS .................................................................................................................. 1 3. INTRODUCTION ................................................................................................................................ 2 4. SPECIFICATION .........................................
1. Revision History Date December 23, 2014 Release 0.1 Author Cindy Fan Description First Release 2. Related Documents Date Author IEEE.org Document IEEE 802.
3. Introduction The WU182-LO is a module based on a highly integrated Wi-Fi single chip which supports 300 Mbps PHY rate. It fully complies with IEEE 802.11n and IEEE 802.11 b/g standards, offering feature-rich wireless connectivity at high standards, and delivering reliable, cost-effective throughput from an extended distance. Optimized RF architecture and baseband algorithms provide superb performance and low power consumption.
4. Specification Specifications Product Name IEEE802.11 b/g/n USB Module Interface USB2.0 in a ROHS 6P header Network Standards IEEE802.11n and 11b/g -compliant 11b/g: Data Rate 54, 48, 36, 24, 18, 12, 9, 6, 11, 5.5, 2,1 Mbps 11n: 20MHz and 40 MHz BW: up to 150 Mbps Modulation 802.11g/n---- OFDM (BPSK, QPSK, 16QAM, 64QAM) 802.11b---- CCK (11Mbps, 5.5Mbps), QPSK (2Mbps), BPSK (1Mbps) Network Architecture Infrastructure and ad hoc Operating Frequency 2.4GHz 11b/g/n: 2.412 ~ 2.
5. Regulatory Information 5.1 FCC Notice (USA) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
the following: “Contains FCC ID: N89-WU182”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
