Owner`s manual

! WARNING: Always use proper lifting methods
when moving heavy items.
4. Lift and move the unit
A. Lift and move or roll the unit using the front
transport wheels to the location where you
intend to leave it. Use proper lifting methods.
5. Attach the Console Assembly to Upright Tube.
A. Locate the console assembly (#2), upright tube
(#4), four mounting screws 5-16-18 X 1.25
(#12) and washers 5-16” (#10). See Figure 3.
B. Locate the upper display cable and ground
wire. Insert the cables into the upright tube
(#4). Pull cables through tube to exit at
bottom. See Figure 4
C. Place the console assembly (#2) in the correct
position on the upright tube (#4) and hand
thread each of the four screws 5-16-18 X 1.25
(#12). See Figure 3.
D. Securely fasten the screws 5-16-18 X 1.25 (#12) with the 3/16” Allen wrench (#14) provided.
6. Attach the Upright Tube to Base Assembly.
A. Locate the four screws 5-16-18 X .75 (#9) and washers 5-16” (#10) . See Figure 4.
B. Locate the upper display cable and plug it into the lower display cable in the main frame
assembly. See Figure 5.
Cybex Sigma-C and Sigma-R Owner’s Manual
Setup
and Assembly
Page 5-5
Figure 3
#12
#10
#2
#4
Upper
Display
Cable
Ground
Wire
Upper
Display
Cable
Upper
Ground
Cable
Figure 4
#9
#10
#2
#4
Figure 5
Lower
Display
Cable
Upper
Display
Cable
Upper
Ground
Cable
Lower
Ground
Cable
#4