Owner`s manual

C. Locate the upper ground cable and plug it into the
lower ground cable on the main frame assembly.
See Figure 5.
NOTE: Ensure cable connectors are securely fastened.
D. Lower the upright tube (#4) over the upper display
cable and hold it steady in the correct position on
the base assembly. See Figure 6.
NOTE: Confirm that no cables are pinched lowering the
console.
E. Using a 1/4” Allen wrench (#15), attach the upright
tube (#4) with the four screws 5-16-18 x .75 (#9)
and four washers 5-16” (#10). See Figure 6.
7. Install the front cap.
A. Locate and place front cap (#3) on the front of the
unit as shown in Figure 7.
B. Using a Phillips head screwdriver, secure with two
screws 8-16 x .50 (#11) and one screw
10-24 x .50 (#13).
Cybex Sigma-C and Sigma-R Owner’s Manual
Figure 6
Base
Assembly
#10
#5
#11
Figure 7
#11
#3
#13
Setup
and Assembly
Page 5-6