Owner`s manual

NOTE: Confirm that no cables are pinched lowering the console.
E. Using a 1/4” Allen wrench (#15), attach the
console assembly (#2) with the four screws
5-16-18 x .75 (#9) and four washers 5-16” (#10).
See Figure 15.
14. Install the top cap.
A. Locate and place top cap on the top of the
unit as shown in Figure 12.
B. Using a Phillips head screwdriver, secure with four
screws.
15. Install the front cap.
A. Locate and place front cap (#3) on the front of the
unit as shown in Figure 16.
B. Using a Phillips head screwdriver, secure with two
screws 8-16 x .50 (#11) and one screw
10-24 x .50 (#13).
16. Connect the Seat Back Assembly.
A. Locate the seat back assembly (#8) four screws 5-16-18 x 1.50 (#12) and four washers 5-16”
(#10).
B. Place the seat back assembly in the correct position and hand thread each of the screws
5-16-18 x 1.50 (#12) and four washers 5-16” (#10). See Figure 17.
C. Securely fasten the screws 5-16-18 x 1.50 (#12) with the 3/16” Allen wrench (#14) provided.
Cybex Sigma-C and Sigma-R Owner’s Manual
Figure 16
#11
#3
#13
Figure 17
#8
#12
#10
Figure 15
Base
Assembly
#2
#9
#10
Setup
and Assembly
Page 5-11