Owner`s manual

Assembly
and Setup
Page 2-10
Cybex 530S Owner’s Manual
WARNING: Be sure that all electrical requirements are met as indicated in the
specifications at the front of the manual and at the beginning of this chapter
prior to proceeding.
Testing the Operation
Use the following instructions to test the full resistance of the unit.
1. Plug the power cord into a power outlet from a grounded circuit as described under Electrical
Requirements in this chapter. NOTE: Coil up the remainder of the power cord and place it out of the
way.
NOTE: Cybex recommends that the unit be unplugged when not in use.
2. Locate the on/off (I/O) power switch on the front of the stepper. Toggle it to the on position (I).
3. Observe that the control panel will illuminate and be in the Dormant Mode.
4. Hold the handrails to steady yourself while you step onto the pedals.
5. Begin stepping.
6. Press the Quick Start key. The unit begins with a long tone then the speed increases to correspond
to the program that you selected.
7. Run the unit through its full resistance range. First press the Level + key until the unit reaches its
highest speed (the display will show “150”). Then press the Level - key until the unit reaches its
lowest speed; the display will show “10”. As you step, you will feel the speed change.
8. Press Pause/End twice to end the workout review and return the display to Dormant Mode.
WARNING: Wait until all moving parts come to a complete stop before dismounting.
9. Wait until pedals come to a complete stop before dismounting the unit. Hold the handrails to steady
yourself while you step off the unit.