Owner`s manual

Assembly
and Setup
Page 2-11
Cybex 530S Owner’s Manual
1. Enter Test Mode by holding down any key while turning on (I) power. The display will read
“Step”.
NOTE: After changing any value, you must press Enter to save that value. When you press
enter the display will read “updt” (updated) to confirm your selection.
2. Press the Time key to set options, change values with
Λ and V keys and press Enter to
save your selection. Each time you press Time the next set of data is displayed in the
following order:
Unit — Choices are “Eng” or “Euro” measurements. English is the default.
Scan — This turns on or off the data readout scan (unless a specific data key is pressed
during a workout). Default is on.
Time — This is the default time for time based programs if a user doesn’t re-set Time. For
example, if you press Time you can decrease or increase the set workout time up to the
amount that the Max time is set. Choices are between 20 minutes and 60 minutes. Default
is 60.
Max: — This is the maximum amount of time the stepper can run per use. You can limit
the users time or choose “none” for unlimited time. Choices are between none and 120
minutes; default is 60. NOTE: If the Max time is limited too much it may be difficult for the
user to reach their goals. For example, a user may not be able to burn 300 calories if you
limit their Max time to 20 minutes.
Idle (or Workout Review/Pause Time): — This is how long the treadmill retains and
displays your current workout data during a pause in the workout or after a workout.
Choices include: 10 seconds; 20 seconds; 30 seconds, 40 seconds; 1 minute and 5
minutes; default is 20 seconds.
Remember: You must press Enter after changing a value for that value to be stored.
3. To exit Test Mode press the Pause/end key twice.
Your stepper is now ready for use. Follow the instructions in the Operation chapter to learn how to
operate the stepper.
Setting Operation Options