Service manual

Cybex 600T Treadmill Service Manual
Key Functions
While in Test Mode press the following keys for desired information:
Start
End
Hills
Endurance
Sport
Manual Key
Incline
•
Incline ~
Speed.
Speed ~
Distance
Pace
Scan
Watts
Calories
Heart
Enter
Error Codes
Starts the belt at 1.0 mph (1.6 kph)
Exits diagnostics
to 'Dormant'
Lights each
LED segment as key is pressed again.
Lights each
LED digit as key is pressed again.
Lights all
LEOs on console.
Toggles E-Stop
relay. Confirm by pulling the E-Stop key off to hear the
relay click off, then replacing it
to hear it click on.
Run elevation motor up.
Run elevation motor down.
Increase drive motor speed.
Decrease drive motor speed.
Press once for odometer information
(DST) to appear in the speed
window.
Press twice for hourmeter information
(HRS) to appear in the speed
window.
Press three times for number
of starts information (USES) to appear in the
speed window.
Press four times for brush wear mileage up
to 100 miles since activated
or
"--" if it has not been activated (BRUSH).
Displays and cycles through error log, up
to 32 errors can be stored.
Clears error log when pressed twice while
in error log mode.
Value
of motor loads in AID counts. The number range is relative to motor
current and goes from 0-225.
Displays motor pulse width (PWM) value. Range
is 0-143.
Displays the number
of starts per program
Press twice to run calibration when PWM
is displayed. Also required to
save setup values.
Page 4-2
NOTE:
born
bAdO
bAd1
A processor upset can cause any of bAdO through 4. If the chip is
misprogrammed the display typically won It run at all. Try turning the treadmill to
the
off (0) position and back on (I). If bAdO through 4 still occurs you may need
to replace the upper display board. See Upper Display Board in the Removal and
Replacement section.
uninitialized EEPROM (loads defaults & enters test mode). Only displayed
on initial power up of a new display board.
EPROM checksum failure
Faulty microprocessor reset