Service manual

Page 4-4
Cybex 600T Treadmill Service Manual
3. Adjust the speed sensor gap.
A. Loosen the Phillips head screw. Adjust the gap between the speed sensor and the
flywheel should be between 1/4 - 5/16" (.635 - .795 cm).
B. Tighten the Phillips head screw.
4. Attach the motor cover.
A. Place rear of the motor cover in the rear guide holes.
B. Lower the front end of the motor cover and install the
two Phillips head screws.
5. Turn power on (I) and test for any speed errors.
6.
If any errors occur, readjust the speed sensor.