Service manual

Page 5-2
Cybex 600T Treadmill Service Manual
-c:::r9
~ ~ J
End Caps _______________
- ~ Phillips Head
~screws
Figure 2
3. Remove the plastic end caps and side rails.
A. Remove the Phillips head screws that fasten each of the plastic end caps in place
and set aside. See Figure
2.
B. Grasp the side rail and firmly slide it out toward the front of the treadmill.
C. Remove the other side rail and set aside.
4. Remove the rear roller.
A. Loosen and remove the two rear roller bolts. See Figure 3. Loosen each bolt
evenly, making sure not
to loosen either bolt too many turns before moving to the
other bolt. Remove the bolts, springs, nuts and washers and set them aside.
B. Lift one side
of the rear roller and slide it out of the running belt.
........ ~
Rear /-A ~
Roller
Rear
Roller Bolts
.. _~ /
~
Figure 3
5. Loosen the deck.
A. Remove the ten bolts, eighteen washers and two belt retaining washers which hold
the
deck in place. Set these aside. See Figure 4.