Service manual

Cybex 600T Treadmill Service Manual
Motor
Lead
Exit
Figure 10
c. Place a spring and bracket over each brush. Hook the bracket in
place. See Figure 10.
13. Replace
the drive motor access panels.
A. Attach each
of the access panels with the two Phillips head screws.
NOTE: When installing the drive motor, rotate the
motor cables toward
the top
so that the cables don't get pinched or damaged. Align
the drive pulley with the drive belt before tightening the motor.
14.
Attach the drive motor.
A. Carefully lower the drive motor
in position. Be sure the four motor
pads are still
in place on the base of the treadmill and the motor
doesn't contact the frame. Place the drive belt loosely around the
drive pulley.
B. Place the mounting strap around the motor over the isolator pad.
The metal mounting strap should not contact the motor. Place the
tee bar inside the hole on the base
of the treadmill and loosely
hand-tighten the nut underneath. See Figure
8.
C. Be sure that the drive pulley is aligned with the drive belt. Using a
torque wrench tighten the nut
to 50 in-Ibs. Do not overtighten.
15. Re-tension the drive belt.
A. Place the drive belt onto the drive pulley.
Table of Contents
i Read All Instructions &Warnings
ii Important Safety Instructions
iv About This Manual
Important Voltage Information . iv
FCC Compliance
Information. iv
V Declaration of Conformity
vii Table of Contents
1 Safety
Warning
Decals. . . . . . . . . .. 1-1
Caution
Decals . . . . . . . . . .. 1-2
2 Technical Specifications
Specifications . . . . . . . . . . .. 2-1
3 Preventative Maintenance
Regular Maintenance ktivities 3-1
Running Belt Maintenance.. 3-3
4 Troubleshooting
Test
Mode 4-1
LED Functions. . . . . . . . .
.. 4-1
Key Functions . . . . . . . . .
.. 4-2
Error Codes . . . . . . . . . . . .. 4-2
Speed Sensor Adjustments. 4-3
5 Removal & Replacement
Running
Deck . . . . . . . . . . . . 5-1
Running Belt . . . . . . . . . . . .. 5-5
Front Roller . . . . . . . . . . . . .. 5-5
Drive Belt. . . . . . . . . . . . . . .. 5-5
Rear Roller. . . . . . . . . . . . . .. 5-6
Drive Motor . . . . . . . . . . . . .. 5-7
Motor Brush . . . . . . . . . . . . 5-10
Elevation
Motor 5-13
Lower Control
Board 5-15
Power Cables 5-16
Une Riter '.' 5-17
Power Switch 5-17
Power
Cord Inlet 5-18
Display
Board 5-18
Heart Rate Board 5-20
Lower Display
Board 5-21
Polar
Board 5-21
Upper Display Cable 5-22
Lower Display Cable 5-24
Display Overlays 5-25
6 Diagrams
Parts
Ust . . . . . . . . . . . . . .. 6-1
Exploded View
6-3
600T Schematic 6-4
7 Customer Service
Contacting Service . . . . . . . . 7-1
Serial Number & Voltage. . .. 7-1
Retum Material Authorization
(RMA) 7-1
Darnaged Parts 7-2
8 Index 8-1
Page 5-11