Manualshelf

Service manual

ManualsBrandsCYBEX ManualsSport & travel600T
31323334353637383940
Page
5-14
Cybex
600T Treadmill
Service
Manual
4.
Replace
the
elevation motor.
A. Lower the elevation motor into the front end assembly.
B. Install the upper clevis pin (longer) and cotter pin. See Figure 12.
C. Lift the elevation swing arm and install the lower clevis pin (shorter) and cotter pin.
Figure 12
5. Calibrate
the
elevation motor.
A. The switch should be at zero elevation before adjusting the tube nut. If necessary
connect the elevation motor, bring the elevation up
to
1% incline and then back
down
to
0%.
Adjust the tube nut
to
11
7/8 -
11
15/16" (30.16 - 30.32 cm) from
center
to
center
of
the mounting holes. No tools are needed
to
adjust the tube nut.
6.
Test
the
elevation motor.
A. Connect the elevation motor into the lower control board.
B. Connect the main power cord into the front panel. Turn the power on
(I).
C. Start the treadmill
in
Manual Mode and raise the elevation
to
6%.
D. Remove the wooden block from under the front end assembly. This will load the