Service manual
Page
5-18
Cybex
600T Treadmill
Service
Manual
6. Replace
the
main
power
switch
if
needed.
A. Unplug the old power switch and replace it by plugging
in
the new power switch.
Power Cord Inlet
NOTE:
If
you are replacing the power cord inlet with a new one follow step
7.
If
not, skip
to step
8.
7.
Replace
the
main
power
cord
inlet
if
needed.
A. Remove the
two
Phillips head screws which hold the power cord inlet
in
place.
B. Plug the main power lines (black and white wires) and the ground wires (green and
yellow) into the lower control board. See Figure
11
and 14.
NOTE: Refer to the Diagrams section to see a wiring diagram.
8. Replace
the
lower
control
board
shield.
A. Check
to
see that all
of
the cables are connected firmly
in
their proper place. Be
sure
to
route the wires through the retaining clips as shown
in
Figure 11.
B. Attach the shield over the lower board bracket using the
two
clips. The red and
black motor cables will go under the corner
of
the shield.
9. Replace
the
front
end
cap.
A. Replace the front end cap using the three Phillips head screws.
10.
Attach
the
motor
cover.
A. Place the rear
of
the motor cover
in
the rear guide holes.
B. Lower the front end
of
the motor cover and install the
two
Phillips head screws
that hold it
in
place.
Display Board
Tools Required
• Phillips head screwdriver
1. Turn
the
power
off.
A. Turn the main power switch
in
the front panel
to
the off (0) position.
B. Unplug the treadmill from the power outlet.