Service manual

Cybex 600T Treadmill Service Manual
Figure 15
2. Remove the console back.
A. Remove the eleven Phillips head screws on the console back. Leave
the
top screw which holds the accessory holder in place. The top
screw will keep the accessory holder in place on the console back.
Set the console back and screws aside. See Figure 15.
3. Remove
the console front.
A. Remove the six Phillips head screws and two star washers which
hold the console front to the handlebar.
4. Remove
the display board.
A. Disconnect all seven cables from the display board (also, the CSAFE
connector if applicable). See Figure 16.
B. Remove the seven Phillips head screws that fasten the display
board to the console. Hold the display board so that it doesn't fall.
C. Remove the display board.
5.
Attach the display board.
A. Place the display board in position on the console front. Attach the
display board with the seven Phillips head screws that hold the
board
to the console. See Figure 16.
6. Connect the cables.
A. Connect all seven cables from the display board (and the CSAFE
connector if applicable). See Figure 16.
7. Attach the console back.
A. Attach the console back and accessory holder with the eleven
screws.
Table of Contents
i Read All Instructions & Warnings
ii Important Safety Instructions
iv About This Manual
Important Voltage Information . iv
FCC Compliance Information . iv
V Declaration of Conformity
vii Table of Contents
1 Safety
Waming Decals. . . . . . . . .
.. 1-1
Caution Decals . . . . . . . . . .. 1-2
2 Technical Specifications
Specifications . . . . . . . . . .
.. 2-1
3 Preventative Maintenance
Regular
Maintenance Activities 3-1
Running Belt Maintenance .. 3-3
4 Troubleshooting
Test
Mode 4-1
LED Functions. . . . . . . . .
.. 4-1
Key Functions . . . . . . . . .
.. 4-2
Error
Codes. . . . . . . . . . . .. 4-2
Speed Sensor Adjustments. 4-3
5 Removal &Replacement
Running Deck . . . . . . . . . . . .
5-1
Running Belt . . . . . . . . . . . .. 5-5
Front Roller 5-5
Drive Belt . . . . . . . . . . . . . .
.. 5-5
Rear Roller. . . . . . . . . . . . . .. 5-6
Drive Motor . . . . . . . . . . . . .. 5-7
Motor Brush . . . . . . . . . . . . 5-10
Elevation
Motor 5-13
Lower Control
Board 5-15
Power Cables 5-16
Une Riter 5-17
Power Switch 5-17
Power
Cord Inlet 5-18
Display
Board 5-18
Heart Rate
Board 5-20
Lower Display
Board 5-21
Polar
Board 5-21
Upper Display Cable 5-22
Lower Display Cable 5-24
Display Overlays 5-25
6 Diagrams
Parts
Ust . . . . . . . . . . . . . .. 6- 1
Exploded
View 6-3
600T Schematic 6-4
7 Customer Service
Contacting Servi
ce . . . . . . . . 7-1
Serial Number & Voltage. . .. 7-1
Return Material Authorization
(RMA) 7-1
Damaged Parts . . . . . . . . . .. 7-2
8 Index 8-1
Page 5-19