Service manual
Page
5-24
Cybex
600T Treadmill
Service
Manual
4.
Remove
the
display
cable.
A. Locate the connector that goes from the upright into the handlebar. If needed
gently use needle nose pliers
to
pull the cable out
of
the handlebar. Unplug the
connector and pull the upper display cable out
of
the handlebar. See Figure 17.
5. Replace
the
upper
display
cable.
A. Locate the handlebar entry hole. It is hidden underneath a bracket near the bottom
left
of
the handlebar.
B. Twist about
8"
(20
cm)
of
the display cable. Twisting will help
to
prevent it from
getting stuck when you push it through the handlebar tube.
C. Put the connector into the entry hole and push the twisted part through. Bend the
remaining cable
in
half as you feed it into the tube.
D. When you see the connector appear at the exit hole on the handlebar, gently grab
the connector with a pair
of
needle nose pliers and pull it out
of
the exit hole.
E.
Plug the connector into the display board.
Lower
Display Cable
NOTE: Before removing the lower display cable begin with the "Upper Display Cable"
procedure above.
6. Remove
the
motor
cover.
A. Remove the
two
Phillips head screws that fasten the motor cover
to
the frame.
B. Lift the cover from the front and remove it from the treadmill. Set the cover and
screws aside. See Figure 1.
7.
Disconnect
lower
display
cable.
A. Locate and unplug the cable connector that goes from lower control board into the
left upright.
B. If the lower cable is still connected
to
the upper cable at the handlebar junction
remove the junction covers as described
in
the "Upper Display Cable" procedure
above. Open the retaining clip and remove the display cable from it. Then pull the
old cable out
of
the upright tube and discard it.
8. Replace
the
lower
display
cable.
A. Locate the entry hole on the left upright near the
top
mounting bracket. See
Figure 17.
B. Twist about
12"
(30
cm)
of
the display cable. Twisting will help
to
prevent it from
getting stuck when you push it through the upright tube.