Service manual
Pageiv
Cybex 600T Treadmill Service Manual
About This Manual
For your convenience, all measurements and voltage requirements are listed
in
both English
and metric units. English values are listed first, followed by metric units
in
parentheses. For
example: 1" (2.54 cm).
An
Owner's Manual
is
shipped with each 600T Treadmill.
To
purchase a copy
of
the Service
Manual contact Cybex Customer Service at 888-462-9239 or 508-533-4300.
To
contact Cybex with comments about this manual you may send email to
techpubs@cybexintl.com.
Important Voltage Information
Before you assemble your
600T,
check to make sure that the treadmill has the correct voltage
requirements for your area, and that you have the correct model.
To
check for the correct model and voltage requirements, locate the serial number label and
voltage label. Your serial number can be found on the rear crossbar under the running deck.
The voltage of your treadmill can be found on a label near the on/off (I/O) switch.
The power requirements for this treadmill
are
115
VAC
±10%, 60 Hz and 20 amps or a 220
VAC
±15%, 50 Hz/60 Hz and 15 amps grounded, dedicated circuit.
! WARNING: Do
not
attempt to use this unit with a voltage adapter.
! WARNING: Do
not
attempt to use this unit with an extension cord.
FCC Compliance Information
! WARNING: Changes
or
modifications to this unit
not
expressly approved
by
the party
responsible for compliance could void the user's authority
to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following
two
conditions:
(1)
This device may not cause harmful interference, and
(2)
this device must
accept any interference received, including interference that may cause undesired operation.