Service manual

Arc Trainer
®
425A A/V
Kit No. 425AK044
Installation Instructions
NOTE: This instruction sheet describes how to install
the Cybex Personal Entertainment Monitor on
the Arc Trainer 425A.
Tools Required
• 3 mm Allen wrench • 7/32” Allen wrench (2)
• 5/32” Allen wrench • Side cutter
• 7/16” Open end wrench • Utility knife
• Phillips screwdriver • Cloth
1. Read and understand all instructions
thoroughly before installing this kit.
2. Verify kit contents shown in Figure 1.
A. Console monitor mount (1), 425A-220
B. Audio cable 1/4” to 3.5 mm 18” (1), 630A-102
C. RJ-45 round cable (1), 630A-103
D. Headphone adapter clamp (1), 630A-330
E. Headphone jack mount bracket (1), 630A-331
F. Coax and power cable I/O W/2.1 mm (1),
630A-104
G. Allen wrench 3 mm (1), BK030210
H. Adapter, 1/4 plug to 1/8 stereo jack (1),
ES000001
I. Self tapping screw 8-16 x .31 (2), HT552509
J. Self tapping screw 8-16 x .75 (2), HT552515
K. Strain relief bushing (1), PP740000
L. A/V bottom membrane (1), SW-19621-4 (NOTE:
for English Console only)
M. Cybex monitor kit (1), EE000005 or EE000007
N. Poster (1), 425A-513 (not shown)
O. Warranty sheet (1), LT-20219 (not shown)
P. Cable Tie (5), EW000028
Q. Signal Isolator (1), 425A-490
R. Loctite (1), YA000201 (not shown)
Figure 2
AA
BB
CC
DD
EE
FF
GG
HH
II
3. Verify the monitor kit contents shown in Figure 2.
AA. Monitor (1), EE000005 or EE000007
BB. Remote control (1), EM000000
CC. Batteries, remote control, AAA size (2), N/A
DD. Screws, mounting, M4 x 0.7 x 10 mm (4),
HC692860
EE. Washers, external lock, (4), HS047300
FF. Washers, flat, M4 (4), HS097600
GG. AC/DC adapter (1), ET300038
HH. Power cord, 115 VAC 60 Hz, (Country specific
cords supplied with product), (1), EW600000
II. Personal Entertainment Monitor Manual (1),
LT-20191
Figure 1
M
F
B
C
L
K
H
D
E
I
J
A
G
P
4. Elevate the unit and disconnect the power source.
A. Elevate the unit to level 10 incline.
B. While the unit is elevated, unplug the power cord
from the power outlet.
Q
! WARNING: Disconnect the power cord before
continuing this procedure. Keep wet
items away from inside parts of the
unit. Electrical shock could occur
even if the unit is unplugged.
5. Remove the input handles.
A. Using a 5/32” Allen wrench, remove the Button
Head Socket Cap Screw (BHSCS), washer,
end cap and spacer securing the S-link to the
input handles. See Figure 3.
NOTE: To protect paint place a cloth over upper
frame before removing handles.