Service manual

B. Unplug the heart rate cables. See Figure 4.
Figure 4
Right Input Handle
Left Input Handle
Pivot Shaft
Washer
Opening
Figure 3
S-Link
End Cap
Spacer
Input
Handle
Heart Rate
Cables
BHSCS/
Loctite
BHSCS/
Loctite
Washer
Grease
Loctite
BHSCS/
Loctite
Grease
Loctite
Figure 5
Screws
(4)
Front
Cover
6. Remove the front cover.
A. Using a Phillips
screwdriver, remove
the four screws
securing the front
cover. See Figure 5.
B. Remove front cover.
B. Remove top cover.
8. Remove upper side covers.
A. Using a Phillips screwdriver, remove the
screw securing each of the upper side covers.
See Figure 7.
Figure 6
Screw
7. Remove top cover.
A. Using a Phillips screwdriver, remove the
screw securing the top cover. See Figure 6.
Figure 7
Locking
Connectors
Upper Left
Side Cover
Screw
B. Remove upper side covers.
Top Cover
9. Remove both lower side covers.
A. Using a Phillips head screwdriver, remove the
four screws securing each of the lower side
covers. See Figure 8.
C. Using two 7/32” Allen wrenches, remove the
BHSCS and washer from the pivot shaft.
See Figure 4.
D. Slide the pivot shaft through main frame
opening to remove input handles. See
Figure 4.
E. Set input handles aside (they will be
reattached later).
Washer