Service manual

B. Position the display console and hand thread
each of the four BHSCS and lockwashers.
See Figure 18.
NOTE: Verify cables are not pinched.
C. Using the 5/32” Allen wrench provided,
tighten the four BHSCS securing the display
console to the console mount.
23. Install monitor
A. Locate monitor (AA), four mounting screws
(DD), four lock washers (EE) and four flat
washers (FF).
B. Remove the back cover from monitor (AA) by
pressing the bottom tabs of the cover in and
rotating out. See Figure 19.
C. Insert the power cable end of (F) through
hole on left side of monitor mount. See
Figure 20.
Figure 19
Figure 20
(AA)
(FF)
(DD)
Monitor
Mount
(EE)
RJ-45
Cable
(F)
Power
Cable
(F)
Coax
Cable
Monitor
Bracket
D
D
(AA)
Back
Cover
Tab
Tab
NOTE: Press in bottom of tabs and rotate out.
Figure 21
To Fitness
Equipment
RJ-45
Power Inlet
12 VDC
Antenna/
Cable
Source
(Coax Cable)
To CSAFE
Device
D. Insert RJ-45 cable and the coax end of (F)
through hole on right side of monitor mount.
See Figure 20.
E. Using a 3 mm Allen wrench secure the
monitor bracket to the monitor mount using
the four mounting screws (DD), four lock
washers (EE) and four flat washers (FF).
See Figure 20.
F. Insert the power cable, coax cable and
RJ-45 cable into the monitor as shown in
Figure 21. NOTE: Use of the CSAFE port is
optional and requires a CSAFE cable and
device.
G. Secure the power inlet cable to the monitor
plate using the cable tie (P). See Figure 22.
Figure 22
Power Inlet
Cable
Secure Cable
Tie Here
Monitor
Plate