Service manual

F. Using two 7/32” Allen wrenches, attach the
two BHSCS/Loctite and two washers to the
pivot shaft. See Figure 4. NOTE: Handle will
wobble if not securely tightened.
G. Attach the heart rate cables. See Figure 4.
32. Attach S-Links.
A. Place the S-links in position on the handles.
See Figure 3.
B. Place a drop of Loctite (R) to the threads of
each BHSCS removed in step 5A and another
drop inside the shaft into where each BHSCS
will tightened.
C. Install the two nylon washers, two end caps
and two BHSCS/loctite as shown Figure 3.
D. Using a 5/32” Allen wrench, tighten BHSCS
securely.
33. Test the unit for proper operation.
A. Connect the power cord into the power outlet.
B. Operate the unit to verify proper operation.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 ● FAX [phone] ● www.cybexinternational.com ● [e-mail]
[e-mail] ● Copyright © 2008, Cybex International, Inc. All rights reserved ● 425A-514 C ● March 2008
Cybex
®
and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer
®
and its mark are registered trademarks of Cybex International, Inc.