Service manual

Cybex Arc Trainer 610A Service Manual
Preventive
Maintenance
Page 2-4
3. Remove the access cover.
A. Using a Phillips head screwdriver, remove the four
screws securing the access cover in place. See
Figure 2.
B. Remove the access cover.
! WARNING: The flywheel may be hot. Wait until it
cools before servicing.
4. Check the condition of each belt.
A. Roll each belt by pulling down on it. Examine the
condition of each belt. If a belt has cracks or
appears worn, it must be replaced immediately
by a qualified service technician.
5. Check the tension of the primary belt.
A. Press on the primary belt with your hand. You
should not feel any “give” in the primary belt. If
the belt “gives”, it must be adjusted immediately
by a qualified service technician.
6. Check the tension of the secondary belt.
A. Press on the secondary belt with your hand. The belt should “give” about 1/4” (0.6 cm). If the
belt “gives”, it must be adjusted immediately a qualified service technician.
B. Locate the spacers under the lower pivot
shaft. Visually check that the spacers are
in place and in good condition. If the
spacers are visibly cracked or missing, it
must be replaced immediately by a
qualified service technician. See Figure 3.
Figure 2
Screw (4)
Access
Cover
Figure 3
Lower Pivot Shaft
Spacers