Owner`s manual

Cybex 625T Treadmill Owner’s Manual
23
CAUTION: A minimum of two people are required to lift, move and assemble this
treadmill. Always use proper lifting methods when moving heavy items.
Lift and move the treadmill.
Take note of doorway widths in facility before assembly. The base is 32.5” (83 cm) wide. With
uprights installed the width is 35.6” (90.5 cm).
At least two people should lift and move the treadmill to a level location where you intend to
1.
leave it. Use proper lifting methods.
Verify the model and voltage.
Verify that you have the correct model and voltage by looking at the serial number label 1.
located at the rear of the unit. See Customer Service Chapter.
Remove shield.
Loosen but do not remove the two front cover screws securing the motor cover using a Phillips 1.
screwdriver.
Screws (2)
Motor
Cover
Front
Cover
Remove motor cover by lifting vertically.2.
Loosen but do not remove the seven screws securing the sheild to the base using a Phillips 3.
screwdriver.
Screws
(7)
Shield
Base
Remove shield by sliding sideways and then vertically off of base.4.