Owner`s manual

Cybex 625T Treadmill Owner’s Manual
34
WARNING: Be sure that all electrical requirements are met as indicated in the
specications at the front of the manual and at the beginning of this chapter
prior to proceeding.
Testing the Treadmill Operation
Use the following instructions to test the full speed and incline range of the treadmill and to check the
belt for proper operation.
CAUTION: During this procedure STAY OFF THE RUNNING BELT! Stand with your feet on
the two steps.
Cybex recommends that the treadmill be unplugged or the on/off (I/O) power switch turned off (O)
when it is not in use.
Without anyone on the treadmill, plug the power cord into a power outlet from a grounded, 1.
dedicated circuit as described under Electrical Requirements in this chapter.
Ensure the power cord is not being pinched under the front of the treadmill.
Locate the on/off (I/O) power switch under the front end of the treadmill. Toggle it to the on
2.
position (I).
The control panel will light up and be in the opening screen.3.
Press the 4. Quick Start key. The treadmill begins a countdown “3...2...1” and sounds a tone
for each count. After it reaches one (1), the treadmill gives a longer tone and then begins
accelerating the belt to reach 0.5 mph (0.8 kph).
The lower left display will show the incline and the lower right display will show the actual
5.
speed.
Press and hold down the
6. Speed + key until the treadmill reaches a speed of approximately 4
mph (6.4 kph), as indicated on the display.
Observe the belt to see that it is running properly; it should stay centered in the middle of the
7.
deck. If you have problems with the running belt operation, see Running Belt Adjustments in
the Preventive Maintenance chapter.
Run the treadmill through its full speed range. First press the
8. Speed + key until the treadmill
reaches its highest speed. Then press the
Speed - key until the treadmill is back to 0.5 mph
(0.8 kph).
As you press the Incline ▲▼ or
9. Speed + - keys, the respective displays will show the actual
incline or speed.
When the treadmill reaches the set incline and speed, the displays will remain steadily 10.
illuminated to indicate that the desired settings have been reached.
Run the treadmill through its full % grade range. Press the 11. Incline ▲ key until the treadmill
reaches its highest grade (15%). Then press the Incline ▼ key until the treadmill reaches 0%
grade.