Owner`s manual

Cybex 625T Treadmill Owner’s Manual
51
Tension and Center the Belt — If the belt is slipping under each step perform this procedure:
Tools Required
3/4” Socket wrench•
Tension the belt.
Use a 3/4” socket wrench to turn each bolt 1/2 turn clockwise. Be sure to adjust each bolt
1.
equally on each side.
Press the 2. Quick Start key.
Press the3. Speed + to bring the speed up to 3.5-4 mph (5.6-6.4 kph). Allow the treadmill to run
for a minute.
Observe the belt to be sure it stays centered. If it is not centered follow 4. the Center the Belt
procedure.
Walk on the belt to see if it still slips. If it does restart this procedure at step 1. If you have to 5.
do this procedure three times and it still slips call Cybex Customer Service. Follow the next
step to be sure the belt is centered.
Be careful not to over tighten the belt. Over tightening the belt can cause the belt to stretch and
require replacement.