Owner`s manual

Cybex 625T Treadmill Owner’s Manual
53
Inspect the edges of the belt as described below.
Tools Required
Phillips screwdriver•
Disconnect the external power source.
Turn the main power switch under the front end of the unit to the off (O) position.
1.
Unplug the treadmill from the power outlet.2.
Check the running belt condition.
Using a Phillips screwdriver, remove the two screws securing the right end cap.
1.
Right End
Cap
Screws (2)
Repeat step 1 for the left end cap.2.
Look at the top surface, seam and edges of the running belt while you roll it by hand. If the belt 3.
has any rips or looks excessively worn the belt needs to be replaced.
If the running belt and deck need replacement refer to a qualied service technician.
Using a Phillips screwdriver, install the screws securing the end caps removed in steps 1
4.
and 2.
Other Preventive Maintenance
Other preventive maintenance activities must be completed by a qualied service technician at the
recommended intervals listed in the Service Schedule at the end of this chapter. These activities
include:
Flipping or replacing the running deck•
Replacing the running belt•
Elevation Motor Lubrication — In time the elevation motor pivot points or tube nut may develop a
squeak. Lubricate the upper and lower bolts and the spacers with a small amount of lithium grease.
You can buy lithium grease at an auto parts store.