Service manual

Assembling the Treadmill
To ensure correct assembly of the treadmill, carefully follow these steps:
NOTES: • In this manual the words “left” and “right” denote the treadmill user's point
of view.
• Two people are needed to assemble this treadmill.
• Leave the anti-static foam on the console until the treadmill is completely
assembled.*
1. Move the base into position.
A. Remove the boxes, parts, and plastic wrapping
(*except for the anti-static foam on the
console handgrips) from the top of the base.
B. Check to be sure that no parts are missing.
C. Clip a wheel on each elevation gear rack. See
Figure 2.
D. Lift the treadmill from the
back and roll it to the location
you intend to leave it.
2. Attach the right upright.
A. Identify the left and right
uprights. The left will have a
decal at the bottom.
B. Attach the right upright to the
base using two button head
screws and two star washers.
Finger-tighten the screws,
leaving them fairly loose at
this time. See Figure 3.
3. Attach the upright cross brace.
A. Attach the upright cross
brace to the right upright
using two button head
screws and two star washers.
Finger-tighten the screws,
leaving them fairly loose at
this time. See Figure 4.
Cybex 700T Treadmill Owner’s Manual
Page 5-4
Screws
Star Washers
Right Upright
Figure 3
Screws
Star Washers
Cross
Brace
Right Upright
Figure 4
Elevation
Gear Rack
Front
Wheel
Figure 2