Service manual

! CAUTION: Be sure that the display cable does not get pinched, cut or damaged
during this process.
5. Attach the console and left upright to the treadmill.
A. Grasp the display cable and hold it against the inside face of the upright while
lifting the console and attached left upright assembly.
B. Place the assembly in position on the treadmill base. See Figure 6. Keep the
display cable away from the elevation rack. Be sure that the display cable does not
get pinched, cut or damaged during this process.
C. Using the Allen wrench, loosely attach two button head screws and two star
washers in three locations; 1.) into the top of the right upright, 2.) into the cross
brace and 3.) into the bottom left upright. See Figure 6.
6. Using the Allen wrench, tighten all the button head screws at this time.
Cybex 700T Treadmill Owner’s Manual
Page 5-6
Display
Cable
1
2
3
Figure 6