Service manual

9. Observe the belt to see that it is running properly; it should stay centered in the middle
of the deck. If you have problems with the running belt operation, see Running Belt
Adjustments in the Preventive Maintenance chapter.
10.Run the treadmill through its full speed range. First press the SPEED + key until the
treadmill reaches its highest speed, 10 mph (16.1 kph). Then press the SPEED - key
until the treadmill is back to 1.0 mph (1.6 kph).
As you press the INCLINE or SPEED increase or decrease keys, the left display will
flash the selected incline and the right display will flash the selected speed. The control
panel will continue to flash these settings as the treadmill “seeks” to reach the selected
incline and/or speed values.
When the treadmill reaches the set incline and speed, the displays will stop flashing
and remain steadily illuminated to indicate that the desired settings have been reached.
11.Run the treadmill through its full % grade range. Press the INCLINE
^
key until the
treadmill reaches its highest grade (15%). Then press the INCLINE v key until the
treadmill is back to 0% grade.
12.Press STOP three times to stop the running belt, end the checkout session, and
return the display to Dormant Mode (with continuous display of the PRESS START
prompt message).
Finish your setup of the 700T by setting the operation options as desired.
Cybex 700T Treadmill Owner’s Manual
Page 5-10