User guide

AutoView 200 Installer/User Guide
8
100-240V , .1A, 50/60 Hz
1
0
!
11. Locate the power cord that came with your AutoView 200 unit. Plug it
into the IEC power connector on the AutoView 200. Make sure that the
power switch is off, then plug the other end of the power cord into an
appropriate AC wall outlet. This outlet must be near the equipment
and easily accessible to allow for unplugging prior to any servicing of
the unit.
12. Power-up your AutoView 200 unit first, then power up all
attached computers.
The AutoView 200 and all attached computers should be
powered-down before servicing the unit. Always discon-
nect the power cord from the wall outlet.