Owner`s manual

Cybex Eagle 11111 Fly/Rear Delt Owner’s Manual
Assembly
Page 4-3
Using an external snap ring pliers, remove the upper C.
snap ring from one of the guide rods and carefully lower
the guide rod. See Figure 6.
Remove lower snap ring and wave washer from the guide D.
rod. Repeat steps 6C and 6D to remove both snap rings
from other guide rod.
If possible, lean guide rods outward, away from machine E.
in order to provide the most room for installing weight
plates.
Slide top weight up and out of machine and carefully F.
set it aside.
Wipe guide rods clean over entire length. Lubricate with light coating of medium weight automotive engine oil.G.
Carefully install each weight plate one at a time. H. NOTE: When installing weight plates, position plates so wide
edges of bushing face upward and narrow edges of bushing face downward. See Figures 7A and 7B.
Slide top weight onto guide rods.I.
Place lower snap ring and wave washer onto guide rod (about 3” from the top end of guide rod).J.
Raise guide rod up through mounting hole and install the upper snap ring.K.
Lower guide rod and secure lower snap ring. Repeat steps 6J - 6L for the other guide rod.L.
7. Belt Routing.
Route belt through pulley bracket in the front shroud A.
and then route end of belt down to the top weight.
Verify the belt clamp on the top weight is positioned B.
properly with the top pulley. NOTE: The belt must
have a straight path from the pulley to the belt clamp.
See Figure 8. NOTE: Figure 8 shows the top view,
looking from the top pulley down to the top plate.
Figure 8
Top Pulley
Set Screw
Belt
Insert
Increment
Weight
Adjusting
Knob
NARROW
bushing edge
WRONG
WIDE bushing
edge faces
upward
CORRECT
NOTE: The narrow bushing
edge must face downward.
Figure 7A Figure 7B
Figure 6
Upper snap ring
Lower snap ring
Frame
Guide rod
Wave washer