Owner`s manual

Cybex Eagle 11111 Fly/Rear Delt Owner’s Manual
Assembly
Page 4-5
Install the three Phillips head screws securing the C.
top (back) shroud. See Figure 14.
9. Install weight plate decals.
NOTE: You have the option to use pounds, kilograms or both.
Slowly and carefully peel off back side of decal. A.
See Figure 15. NOTE: When peeling off back cover,
make sure that the decals remain attached to the
front sticker.
Align holes in decal with appropriate holes in weight stack.B.
NOTE: Do not allow the adhesive to touch weight stack
at this time.
Insert a guide pin through each hole of the template. C.
NOTE: A guide pin can be anything that fi ts through
the weight stack hole, such as a weight stack selector pin.
Carefully align decal and rub it onto weight plates. D.
Carefully remove front side, leaving decals adhering E.
to weight plates. See Figure 16.
NOTE: It is important that you perform regular inspection
and maintenance activities on your equipment.
See Chapter 6 of this manual for inspection and
maintenance activities. If you do not have a CYBEX
Eagle Owner’s Manual or if you have any questions
or concerns, call CYBEX Customer Relations at
888-462-9239.
10. Verify proper operation
11. Anchor machine to the fl oor.
Securely anchor machine to the fl oor using A.
the anchor holes provided in each machine.
NOTE: Cybex is not responsible for the actual anchoring
of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs. tensile
capacity (3/8” grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT
pull down with anchors. Shim any leg or frame not
in contact with surface using fl at washers.
180
81.0
144.0
135.0
126.0
117.0
108.0
200
99.0
90.0
300
280
260
240
220
320
340
153.0
20
9.0
72.0
63.0
54.0
45.0
36.0
40
18.0
140
120
100
80
60
160
Figure 16
Pounds
Weight Stack
Guide Rod
Kilograms
Figure 15
Front
Back
Figure 14
Phillips Head
Screw (3)