Owner`s manual

Cybex Eagle 11170 Glute Owner’s Manual
Assembly
Page 4-4
Pull belt tight and secure belt to clamp with the two E.
set screws. NOTE: Torque set screws 300-350in./lbs.
See Figure 9.
Place weight stack pin in each plate to verify proper installation.F.
Without selecting any resistance, lift top weight G.
up and down (simulating normal operation).
Have an assistant verify that the belt is moving smoothly and is H.
routed straight from the top pulley bracket to the
top weight belt clamp.
Reinstall the six increment weights that were removed I.
in step 6B. See Figure 10.
Turn the Increment Weight Adjusting Kob to select all J.
15 lbs.
8. Install back shrouds.
Carefully place shroud assembly back into position A.
on the two bottom screws. See Figure 11.
Install the top two screws securing the back shroud B.
assembly. See Figure 12.
Install the three Phillips head screws securing C.
the top (back) shroud. See Figure 13.
Figure 11
Screw
Figure 12
Screw
Figure 9
Belt
clamp
Belt
Belt clamp
insert
Set screw
Figure 10
Figure 13
Phillips Head
Screw (3)
WRONG
CORRECT
Increment
Weights