Owner`s manual

Cybex Eagle 11181 Hip Abduction/Adduction Owner’s Manual
Assembly
Page 4-4
Install the top two screws securing the back shroud. B.
See Figure 10.
Route weight stack belt through the slot in the back C.
shroud (moving from bottom to top).
Properly route belt around upper pulley and down D.
to weight stack.
Install the three Phillips head screws securing the E.
top (back) shroud. See Figure 11.
Carefully lift top weight and verify that the position of the F.
belt clamp (on the top weight) is aligned properly with the
top pulley bracket (on the machine). See Figure 12.
Slide belt through slot in belt clamp.G.
Verify belt and insert are installed properly, as shown H.
in Figure 13A. NOTE: Do not install the insert backwards
as shown in Figure 13B.
Pull belt tight and secure belt to clamp with the two I.
set screws. NOTE: Torque set screws 300-350 in./lbs.
See Figure 14.
Place weight stack pin in each plate to verify proper J.
installation.
Without selecting any resistance, lift top weight up K.
and down (simulating normal operation).
Have an assistant verify that the belt is moving L.
smoothly and is routed straight from the top pulley
bracket to the top weight belt clamp.
Figure 14
Belt clamp
Belt
Belt clamp
insert
Set screws
Figure 12 (top view from pulley down to belt clamp)
Top Pulley
Belt
Increment
Weight
Adjusting
Knob
Insert and Set
Screws (not
shown) are on
this side.
Figure 11
Phillips Head
Screw (3)
Correct belt routing Wrong belt routing
Stem
Belt
Insert
Stem
Belt
Insert
Figure 13A
Figure 13B
Figure 10
Screw