Specifications

33
5 / M
AINTENANCE
Your CYBEX 400T is a high-quality machine that is built to last.
Many CYBEX products are still in daily use twenty years after the
original date of their manufacture. Although no one can guarantee
that your 400T will last that long, one thing is certain — simple
routine cleaning and a preventive maintenance program go a long
way toward extending the life of your fitness equipment.
Preventive Maintenance
CAUTION: To prevent electrical shock, be sure that power is
shut off and the treadmill is unplugged from the electrical
outlet before performing any cleaning or maintenance
procedures.
Use the Service Schedule on page 36 and the following routine to
help insure your treadmill’s long life:
After each use
Wipe up any liquid spills immediately. After each workout, use a
damp cloth to wipe up any remaining perspiration from the
handrails and painted surfaces.
Be careful not to spill or get excessive moisture between the edge
of the display panel and the console, as this might create an
electrical hazard or cause premature failure of the electronics.
When cleaning your treadmill spray a mild cleaning solution on a
clean cloth first, and then wipe the treadmill with the cloth.
Cleaning the Treadmill
Vacuum any dust or dirt that might accumulate under or around the
400T. Motors are especially susceptible to dust and dirt, and a restricted
airflow can prevent adequate cooling that could shorten motor life.
To clean the motor components, you must remove the plastic front
roller cover. Remove the four 1/2-inch button-head screws (one on
each side and two in the front) that hold the cover in place, using
the 5/32-inch Allen wrench included with your treadmill. Lift the
cover and put it and the screws aside. Use a vacuum attachment or
hand vacuum to clean the exposed elevation assembly and the
surrounding areas.
Also use a cloth for the areas that you can’t reach with the vacuum
cleaner. If the machine has not been used for some time or is
excessively dirty, use a cloth to wipe all exposed areas. Replace the
cover and screws when finished.
With the help of another person, pick up the treadmill from the rear and
stand it on its front end, bringing the front console to rest on the floor.
Vacuum and clean the underside of the 400T to prevent dust and
dirt build-up. Again, a cloth may be required if it appears
excessively dirty or dusty. When finished, return the treadmill to its
normal position.
CAUTION: TO PREVENT ELECTRICAL
SHOCK, BE SURE THAT POWER IS
SHUT OFF AND THE TREADMILL IS
UNPLUGGED FROM THE ELECTRICAL
OUTLET BEFORE PERFORMING ANY
CLEANING OR MAINTENANCE
PROCEDURES.
WARNING: Do not spray cleaning
solution directly on the treadmill. Direct
spraying could cause damage to the
electronics and may void the warranty.
Preventive maintenance — routine
cleaning of the 400T reduces the
chance of wear.
Cleaning — wipe up any perspiration or
dirt that accumulates during use.