Specifications

42
6 / T
ROUBLESHOOTING
If the speed attempts to increase, it may be because of a defect
in the power supply circuitry to the drive motor, the speed
sensor, or the filter capacitor.
If the speed attempts to decrease, it may be because of a defect
in the drive motor, the speed sensor, or a worn running deck.
If either of these conditions exist, call your local CYBEX dealer
or CYBEX Customer Service. An authorized CYBEX technician
can usually detect the source of the problem with a service visit.
ERR 7: LOSS OF NOVRAM
This error code indicates a problem with the nonvolatile random
access memory (NOVRAM) contents. The NOVRAM chip is
located in the DDM (Digital Display Module). Its contents may
have become lost or destroyed. Among other data, this chip
holds the accumulated miles and time information. You can
reset the NOVRAM error by turning the treadmill off and then on
again, but you may lose all of the accumulated data. Should the
problem recur, you will need to replace the microprocessor chip
or the DDM.
Diagnostic Tests
d1: SOFTWARE REVISION
d2: ACTUAL SPEED
d3: CURRENT DRAW
d4: INCLINE, INCLINE VOLTAGE, and CALIBRATION
d5: LED TEST
d6: KEYPAD TEST
d7: TOTAL TIME
d8: TOTAL DISTANCE
d9: NUMBER OF STARTS
d10: SPEED SENSOR
d11: ERROR LOG
d12: LOG CLEAR
STOP: Used to exit Diagnostic Test mode.
Note: The diagnostic tests can be accessed while the treadmill is
in the dormant mode or while it is running.
To access the diagnostic tests, press and hold the SHIFT key,
then the - key. Once the diagnostic mode is entered, “d1,”
representing diagnostic test 1, will be displayed in the left
control panel window and the test results will be displayed in
the right display window.
To advance to a specific diagnostic test, press the START key to
scroll forward or the SHIFT key to scroll backward through the
menu of tests.
To exit the diagnostic test mode, press the STOP key at any
time. This will return you to the mode you were in before
entering the diagnostic tests.