Instruction Manual

Cyclades-PR1000
29Chapter 4 - Step-by-Step Instructions
STEP FIVE
Since a modem is used in the example, the dial-out table must be configured. This is done as shown in Figure 4.6.
Menu
CONFIG=>SYSTEM=>MODEMS=>DIAL OUT TABLE=>ADD
Parameter Example Your Application
IP Address Type in any valid IP address not on
the local network.
Init String at
Dial String atdt+phone number of access
provider.
Authentication Method PAP/CHAP/BOTH—depends on the
service provider.
Login Name Login name device receiving call is
expecting.
Password Password device receiving call is
expecting.
FIGURE 4.6 MODEM DIAL-OUT TABLE PARAMETERS