Instructions / Assembly

clamp the quick release with the correct pressure.
In order to ensure that the hub is clamped sufficiently in the hollow axle, the quick
release lever must begin gripping as it moves from the open to the middle position,
and approaching the closed position you should clearly feel resistance as you tighten.
If it is too easy or too difficult to move the quick release lever, tighten or loosen the
quick release nut on the other side of the hub.
WARNING: The thread of the quick release nut must be tightened on the quick
release axle by at least 5 full turns, so that adequate clamping force is ensured. A
quick release axle with is too short can result in accidental loosening of the rear wheel
and therefore cause serous injury or death. If in doubt, contact your specialist dealer.
Insert the safety pin through holes in both hitch and hitch connectors. Rotate and lock
up the pin.
Wrap the safety strap around the chain stay and fasten it to the tow bar D-ring with the
snap hook.
WARNING! Hitch and safety strap must be properly installed. Inspect the hitch and
tow bar frequently for any damage or loose fasteners. Damaged or improperly
installed can result in serious injury or death.
The belt system:
Handling the belt system
1:Shoulder strap of the Y-belt
2:Lower receptacle of the Y-belt
3:Fastener for the Y-belt
4:Lap belt
Strapping your child into the trailer Seat your child in the middle of the trailer.
To strap your child in with the belts, take the belt (1)
through the eyelet on the upper part of the belt (2)
and close the belt by putting the fastener of the belt (1)
in the belt fastener (3). Always remember to strap your
child in with the lap belt (4) as well.