User's Manual
34
step 2 Beginning of the recording:
∫ Start the recording
4sec. ≈ Switch on/switch off the acoustic pulse signal
step 3 End/interruption of the recording:
AUTOMATIC depending on timer selection at the end of the respective
timer or at the end of all selected repeats with the combination function
timer 1+2
∫ Manual interruption = stop recording
step 4 Display of the values (even during recording):
≈ Display data via the LIMIT LO HI pulse menu (display
automatically shows the times for the three ranges
in %)
- Time above the high limit
- Time between the limit values
- Time under the low limit
step 5 Deleting recorded data
4sec. ∫
Note: All bicycle altitude and pulse function can also be called up during
timer operation via the ç √ ¥ ≈ buttons.
TIP: At the end of the training unit measure the recovery time or the
recovery pulse to determine your training status, see chapter 7.4.
Recovery time and recovery pulse.
14.3. TRAINING WITH THE COUNTDOWN TIMER:
The countdown timer is a programmable timer with reverse counting.
This is particularly well-suited for use in time trials. At the end of the
COUNTDOWN time there is a single beep.
IMPORTANT: During countdown operation the residence periods of the
pulse frequency in the selected training ranges are recorded (compare
13.1)
step 1 Preparing the recording:
- Set the training ranges automatically chapter 7.1, or manually chapter
7.2
- Select training program limit 1, limit 2, limit 3, chapter 7.3
- In the setting menu TIMER SETTINGS select AND set the countdown
timer, chapter 13.1 and following.
step 2 Beginning of the recording:
∫ Start the recording
4sec. ≈ Switch on/switch off the acoustic pulse signal
step 3 End/interruption of the recording:
AUTOMATIC after the countdown time elapses
∫ Manual interruption = stop recording
step 4 Display of the values (even during recording)
≈ Display data via the LIMIT LO HI pulse menu
(Display automatically shows the times for the three ranges in %)
- Time above the high limit
- Time between the limit values
- Time under the low limit
step 5 Deleting recorded data