User's Manual

36
walk mode)
Footer: Lap number and time of the lap
∫ Changing the display of values for lap 2
∫ Changing the display of values for lap 3
...
During or after lap training the pulse data can be displayed at any time:
Display data via the LIMIT LO HI pulse menu (display automatically
shows the times for the three ranges in %)
- Time above the high limit
- Time between the limit values
- Time under the low limit
step 5 Deleting all recorded lap data
4sec. ∫
TIP: At the end of the training unit measure the recovery time or the
recovery pulse to determine your training status. See 7.4. Recovery
time and recovery pulse
15. SLEEP MODE
Your VDO computer has a two-stage sleep mode.
Sleep mode is activated automatically if the computer no longer
receives data.
Phase 1 after 5 minutes: - The display goes into sleep mode
Now the display shows temperature, time, date, and day of the week.
.After an additional 10 minutes the second phase of sleep mode will be
activated, will be activated, the receiver will be switched off.
FOR WAKE UP press any button.
Description special case 1.
No speed signals (e.g. when taking a break
No cadence signals (e.g. when taking a break)
Pulse signals will continue to be received (e.g. computer on wrist)
In this case the receive channels for speed and cadence are opened for
a total of 3 hours. Energy is consumed in this process.
To extend the service life of the batteries, leave your VDO computer in
the handlebar holder and move out of the receive range, or take off the
pulse transmitter belt.
16. TROUBLESHOOTING
Here is a list of possible errors, their causes, and what you can to
correct the error:
Problem when pairing the speed
transmitter/cadence transmitter
- Check the magnet position
(distance between magnet
and transmitter, position of the
magnet to the transmitter point
on the transmitter)
- Check the battery in the
transmitter
- Check the battery in the
computer (if battery voltage is
insufcient then the receiver
cannot receive the signals)