User's Manual

23
INSTRUCTION MANUAL
be closed. In this case your VDO computer will show dashes for the
respective function in the display. To re-open all receive channels press
the ç and ¥ buttons at the same time:
In this case your VDO computer will then receive all paired transmitters
that are in range. See also chapter 15. Sleep mode.
11.3. GETTING STARTED - quick overview
Functions/operation/reset/max values
11.3.0. PERMANENT FUNCTIONS
The following functions are permanently shown in the display:
HEADER
- Actual altitude
- Actual temperature
- Actual ascending gradient in percent ! Not in walk mode !
CENTER BAR
- Heart rate receive icon if the pulse transmitter belt is worn
- Beeper icon if the beeper is switched on
- Stopwatch icon if the timing function is running
- Actual heart rate
- Actual speed: Maximum value 120 km/h or mph (! not in walk mode !)
- Actual cadence
- Comparison of actual speed to average speed = above, =below
(! not in walk mode !)
- Selected wheel size 1 or 2
FOOTER
- Shows selected information and corresponding value
ALTITUDE FUNCTIONS (button ¥ )
Re-calibrating the air pressure to home altitude. Short-cut press the ¥
button for 4 seconds.
11.3.1. ¬ £ ALTI UP = uphill altitude gain for the actual trip
Display ¥ ALTI UP
Reset: 3 sec. √ TRIP DATA ?RESET?
‚ TRIP DATA ?RESET? <<?RESET?>> ashing
‚ TRIP DATA RESET DONE
l
Automatic return to operation mode for TRIP DIST
11.3.2. ¬ DIST UP = uphill distance of the actual trip
Display ¥ DIST UP
Reset: 3 sec. √ TRIP DATA ?RESET?
‚ TRIP DATA ?RESET? <<?RESET?>> ashing
‚ TRIP DATA RESET DONE
This resets all data of the functions marked by
l
Automatic return to operation mode for TRIP DIST
Note: The minimum altitude change for the correct distance measure-
ment must be 1 m
11.3.3. ¬ £ TRIP MAX = maximum altitude of the actual trip
Display ¥ TRIP MAX
Reset: 3 sec. √ TRIP DATA ?RESET?
‚ TRIP DATA ?RESET? <<?RESET?>> ashing
‚ TRIP DATA RESET DONE
This resets all data of the functions marked by
l
.
HOM E ALTITUDE