Cyclone360 Wirless Controled LED Effect Lighting Fixture User’s Manual
Introduction The Cyclone360 is a unique wireless controlled LED fixture with a 360 degree beam. A microprocessor controls the 16 million available colors of each of the 8 individual clusters. Built in special effects are all controlled by the user using a wireless transmitter from 400 feet away. Communication is RF (radio frequency) so line of sight is not required. The Cyclone360 has two modes of operation. Single Mode and Octal Mode.
Cyclone360 Overview This maunal covers both Cyclone360-8 and Cyclone360-5. All fixture operating functions are identical. A: Antenna, receives the RF data. Keep all metal objects at least 3 inches away for best performance. B: Tilt Adjustment Knob, secures fixture tilt position from 0 to 90 degreens C: Mounting Base, Keyed base to mount fixture to battery pack or fixture stand. D: Status Indicator, identifies fixture operating mode. E: Program button, enables program to auto addressing fixture.
Controls The following instructions are for Octal Mode only Table below list the function of each channel and the functions of the RED, GREEN and BLUE dimmer buttons.
Below are two charts for the Fade Time and Follow Time values.
Patterns When patterns are activated all 8 clutsers sequence to the selected pattern. Each pattern has 8 steps which continuously loop until the pattern in changed or the effects are disabled. Below is a diagram of all 5 patterns and the chase sequence each will use. The Q10 (BLUE) Foward or Reverse effects with change the sequence direction. Pattern 1 Pattern 2 Pattern 3 Pattern 4 Pattern 5 Editing Cluster Colors LED cluster colors can be changed while a pattern is running.
Introducing ColorRoll™ Technology by ColorMaker Inc. What is ColorRoll ? ColorRoll is a technology developed by ColorMaker Inc. to operate on the ColorMaker line of wireless LED fixtures. When activated a colletion of colors are transmitted to the fixture by a remote. Once the fixture receives the packet of data which takes less that 1 second the fixture will start rolling throught the colors fading from one color to the next with flicker free transition.
How do I remove the dead spot in my ColorRoll ? We need to tell the remote that the 4th color which is OFF is not part of the pattern. The way we do this is to make the colors not in the pattern the same as the last color in the pattern. The last color in the pattern is Blue so we would set Q4 to blue, Q5 to blue, Q6 through Q10 to Blue. Now when the ColorRoll runs it will see Red, Green then Blue when it gets to the 4th color its still blue so it checks colors 5,6,7,8,9 and 10.
Adjusting the ColorRoll Fade Rate Example: 1) Start a ColorRoll by selecting a fixture, Q1 will be fine. 2) Press a ColorRoll button which has been previously programmed. 3) After pressing a ColorRoll button the Red and Green UP and DN dimmer keys become Rate Keys. 4) Press the Red DN button and bring the Rate to 0 if not already inicated by the display. Do the same for Green. The ColorRoll is now running at full speed roughly 3 seconds per color.
9
Warranty ColorMaker Inc. hereby warrants, to the original purchaser, ColorMaker Inc. products to be free of manufacturing defects in materials and workmanship for a period of (90 days) from the date of purchase. This warranty shall be valid only if product is purchased within the United States of America. It is the owners responsibility to establish the date and place of purchase by accepting evidence, at the time service is sought. For warranty service, send the product to the ColorMaker Inc. factory.
