Use and Care Manual

USE AND CARE GUIDE
MODELS
CYS1000R
OPERATION INSTRUCTIONS
Fan Operation
Fan Speeds: In this unit, a dedicated rocker switch controls the single fan with either HIGH or
LOW speed settings using the left switch located on the front of the machine.
Lights: A second rocker switch on the right dims the light on HIGH or LOW brightness
Firmly press your ngers against the light bulb and twist in a clockwise direction until
loosened.
MAINTENANCE
FAN CONTROLS
HIGH
speed
LOW
speed
OFF
LIGHT
CONTROL
HIGH LOW
OFF
Your new fan features a unique, completely lter-less design. Oil and grease are separated
from the airow via non-stick coated fan blades. The grease is then pushed through rubber
tubing into convenient easily-removable grease cups for hassle-free, environmentally-friendly
cleaning. Simply remove the cups when grease builds up and clean them in the top rack of
your dishwasher.
Tip: Soak all parts in soapy water if there is heavy grease.
Grease Disposal
WARNING! Do not remove grease cups immediately after cooking or if grease is still hot.
Fan Blades: Fill a spray bottle with a mixture of dishwasher soap and water and spray into
the fan blades while the machine is running. The soapy water will run the same path through
the machine as the grease, effectively cleaning all of its internal components. The cleaning
solution will be dispensed in the grease traps for convenient, hassle-free disposal.
Exterior: The exterior of the machine can be maintained by wiping the surface area. Use a
stainless steel cleaner and a very gentle cloth for stainless steel machines. A gentle cleaning
agent, such as Windex, and a damp cloth can be used to wipe and buff machines with colored
nishes.
Fan Guard: To clean fan guard, unscrew two screws from the side of the fan guard, then soak
and hand-wash with dish soap.
Cleaning
WARNING! Ensure that all power leading to your range hood has been disconnected
before disassembling any parts.
Changing Light bulbs
WARNING! Ensure that all power leading to your range hood has been disconnected
before changing bulbs. As well, ensure that lights have fully cooled before changing bulbs.