Owner`s manual

10E20 / E25 ELLIPTICAL

1. Attach front (89) and rear (90) Handle Bar Covers together on left Swing Arm

shaft, and secure using two Sheet Metal Screws (122) and the Phillips Head

Screw Driver (150). Repeat this process on the right side with Handle Bar

Covers (91) and (92).

2. Install Console Mast Covers (L & R) (81 & 82) on each side of the Side Cases

and secure with two Sheet Metal Screws (122) and the Phillips Head Screw

Driver (150).

3. Secure left Slide Wheel Cover (87) on left Pedal Arm with two Phillips Head

Screws (120) and the Phillips Head Screw Driver (150). Repeat this process for

the right Slide Wheel Cover (88).

4. Snap Rear Bar Cover (97) into the hole on the Incline Rail Assembly.

PLASTIC PARTS

HARDWARE STEP 4

1. Connect the Upper Swing Arm (L) (18) to the left Lower Swing Arm and

connect the Upper Swing Arm (R) (19) to the right Lower Swing Arm , and

secure them with six Hex Head Bolts (106), four Curved Washers (143) and six

Nyloc Nuts (129) by using the Wrenches (151 & 152).

UPPER SWING ARMS

HARDWARE STEP 3

See Page 11 for Illustration

#106. 5/16” x 1-3/4”

Hex Head Bolt (6 pcs)

#129. 5/16” x 7T

Nyloc Nut (6 pcs)

#143. 5/16” x 23mm

x 1.5T Curved Washer

(4 pcs)

E20 ASSEMBLY INSTRUCTIONS

#120. M5 x 15mm

Phillips Head Screw

(4 pcs)

#122. Ø3.5 x 12mm

Sheet Metal Screw

(6 pcs)