Specifications

20
Fader mode On and Resolution (8/16 bit) mode to 8. If the unit is not set into
these modes then it will be forced into these modes while programming the cues.
When programming cues the display will not time out and go blank. Holding
down the menu button will quickly scan across the menu options “Cu1” through
“Cu8”.
Fixture Physical Setup
Mounting and Adjusting the Fixture
Adjusting the C-clamp
•
Connect a C-clamp to the yoke with the yoke bolt and washer.
•
Hang C-clamp on mounting pipe and secure with the C-clamp pipe bolt.
•
Connect the safety cable to the mounting pipe.
•
Cygnus™ can be rotated to the desired position by loosening the pan screw,
setting the position, and tightening the pan screw to hold the
position.! !
Attaching Accessories to the Front Holder
Cygnus™ 200W can accept up to two standard 7.5” accessories. The 100W can
accept one 5.75” accessory. Accessories are safely held in place with a standard
spring-loaded latch.
•
From the rear of the fixture, pull the accessory ring toward you.
•
Load the accessory into the accessory slot in the front of the Cygnus™, then
release the ring.
•
The plunger will return to the initial position and hold the accessory in place.
Connecting AC Power
⚠ CAUTION: Be sure the fixture is properly grounded.
Use a good source of AC power that complies with local building and electrical
codes and has both overload and ground fault protection.
Input power must be 100-240VAC, 50/60Hz.