Owner's manual

PRODUCT MANUALPRODUCT MANUAL
3332
USB INTERFACE MODE UPDATING THE FIRMWARE ON YOUR LP-16
16.2.6. Settings View: About Tab
Revision
Displays the revision number of the control panel itself.
Live Player LP-16
Displays the connection-status for the LP-16, indicating if the device is connected and recognized
by the computer.
Serial Number
Displays the specic serial number of the connected LP-16 unit.
Driver Version
Displays the version number of the installed device driver
Firmware Version
Displays the current rmware version of the connected LP-16 unit.
16.3. Using the LP-16 as an Audio Interface with OS X
16.3.1. Minimum System Requirements
Operating Systems:
• Mac OS X® 10.8
Hardware:
• Any Mac hardware compatible with OS X 10.7 or higher
• 512 MB Ram (1GB or more recommended)
• 1 free USB 2.0 compatible port
! NOTE:Thespeedofyourprocessor,amountofRAM,andcapacity,size,andspeedofyourhard
driveswillgreatlyaffecttheoverallperformanceofyourrecordingsystem.
A faster processor and more RAM can reduce signal latency (delay) and improve overall
performance.
16.3.2. Driver Installation
There is no driver installation for OS X Computers necessary. Simply connect the LP-16 to your
Mac® by connecting the supplied USB cable to the LP-16 USB2.0 connector on the rear panel,
and an available USB2.0 port on your Mac.
The device will now be selectable in the “Audio MIDI Setup” application, which can be found in
the Applications/Utilities folder.
Note that no custom LP-16 mixer control panel is available for the Mac, as there is when using
the LP-16 with Windows. The internal DSP mixer of the LP-16 is not available when connected to
a Mac, so all monitoring must be done through the DAW software.
16.4. Using the LP-16 as an Audio Interface with an Apple® iPad®
16.4.1. Minimum System requirements
Operating Systems:
• iOS® 5 or higher
Hardware:
• iPad® 2 or newer
• Apple® iPad Camera Connection Kit
• Apple Lightning to USB Camera Adapter
16.4.2. Driver Installation
There is no driver installation for the iPad® necessary. Simply connect the LP-16 to your iPad®
by connecting the supplied USB cable to the LP-16 USB2.0 connector on the rear panel and the
iPad® using the appropriate Apple USB adapter.
The LP-16 can now be used as a 2-input, 18-output audio interface with the iPad® and appropriate
iOS recording software.
17. UPDATING THE FIRMWARE ON YOUR LP-16
Please check the Cymatic Audio website (www.cymaticaudio.com) for any available rmware
updates.
The LP-16’s currently installed rmware version is shown briey on the start screen when the unit
is powering up and can also be found in the PC Mixer Panels ‘About’ tab
If you nd that your rmware version number is lower than the latest rmware released on
the website, please download and install the newer rmware, following the instructions that
accompany the rmware download le.