User's Manual

2/2020 CY-0090-018, Rev.A Page 20 of 49
Remove clear plastic liner from top of electrode. After removing the
clear plastic liner, place the reusable black electrode cover from
packaging or the old electrode on the new electrode. Repeat the above
steps for the other two electrodes.
5 e-vive™ OPERATING INSTRUCTIONS
5. 1 Cha rgi ng a nd Stor in g t he e -vi ve™ Co nt rol ler
When not in use, the e-vive™ controller can be stored in the docking
pod attached to the conductive garment.
To charge the controller, undock it from the docking pod and attach the
supplied USB charging cord to a standard 5V wall adapter charger. Plug
the small, micro USB end of the USB cable into the side of the e-vive™
controller. While charging, the LED light (near the USB charging port)
will blink blue until fully charged. Once fully charged, the blue LED light
will stop blinking and remain a solid blue until the charging cable is
removed.